Skip to content

MotionCoreRobotics motion control, from config file to step pulse

A plugin-first, hardware-independent motion engine in Rust, with shared MCU firmware for STM32F411 and RP2040, a simulator, a firmware builder, a CLI, and an optional Go gateway and web UI.

MotionCore

Status: v0.2 development

MotionCore runs end-to-end in simulation. The STM32F411 and RP2040 firmware compile and are host-tested, but have not been validated on hardware. Nothing here is a certified safety system — always use an independent hardware E-stop that removes driver power.

Apache-2.0 OR MIT. Not a certified safety system — always use an independent hardware E-stop.